12 Mini-LED reverse lights (drilled into rear bumper)

[Sodo]

Haha ALERT THE AUTHORITIES!

Never heard of someone getting in trouble for lights.

Also, this is kind of a "minimalist" mod. The fella who adds a big red danger switch wouldn't have no minimalist mod - his is a 36" lightbar in the middle of the tailgate :laughing:

 

[timswi]

Haha ALERT THE AUTHORITIES!

Never heard of someone getting in trouble for lights.

Also, this is kind of a "minimalist" mod. The fella who adds a big red danger switch wouldn't have no minimalist mod - his is a 36" lightbar in the middle of the tailgate :laughing"

In PA and some other states non-factory lights can trigger unwanted attention. They look like a nice addition, just hope they are aimed so no one gets blinded when backing up..

 

[Sodo]

Need help finding hardware.

Want to protect LEDs from backing into something. Does anybody know where I can get a recessed washer similar to the aircraft partno AN975-6 AN975 TAPER PIN WASHERS from Aircraft Spruce

I want something thats black aluminum or black nylon. To fit inside the recess, the head diameter is .69" and the height of the LED is about 3/8". Cost to replace damaged LEDs is not much ($20 for 12 LEDs) but rewiring is some effort.

Lots of cabinet feet are available but they're rubber. Hard black plastic or nylon is better. If I only had a lathe,,,,,,, hmmmmm wonder if I could make them on a drill press? For that i'd need some black nylon rod about 1-1/4" diameter,,,,,

 

[aczlan]

Need help finding hardware.

Want to protect LEDs from backing into something. Does anybody know where I can get a recessed washer similar to the aircraft partno AN975-6 AN975 TAPER PIN WASHERS from Aircraft Spruce

I want something thats black aluminum or black nylon. To fit inside the recess, the head diameter is .69" and the height of the LED is about 3/8". Cost to replace damaged LEDs is not much ($20 for 12 LEDs) but rewiring is some effort.

Lots of cabinet feet are available but they're rubber. Hard black plastic or nylon is better. If I only had a lathe,,,,,,, hmmmmm wonder if I could make them on a drill press? For that i'd need some black nylon rod about 1-1/4" diameter,,,,,

Looks like you need AN975-12 (same thing, but with a 3/4" ID per http://everyspec.com/AN-SPECS/AN100-AN999/download.php?spec=AN975_REV-3.027179.pdf)

Aaron Z