1231 loader specs?

[Agentiron]

Does anyone know where I can find the specs on the 1231 loader? The Kioti site gives the same specs as the 1230 which I believe is an error.

Thanks

 

[Batche33]

Here's a scan from Kioti's implement & attachment guide

 

[gamble77]

Bucket Size: 60"
Max. Lift Height: 97"
Clearance with bucket dumped: 73.5"
Reach at max. height: 24.5"
Max. dump angle: 51 degrees
Rollback angle: 30 degrees
Digging depth below grade: 5.5"
Lift capacity to full height at pivot pins: 1,320lbs
Breakout force at pivot pins: 1,935lbs
Approx. weight w/bucket: 870lbs

Hope this helps, this is a stout little loader for a 30hp machine.

 

[Agentiron]

Thank you so much gentlemen, that is exactly what I was looking for! It indeed is a stout little loader!

 

[Batche33]

Your welcome, if the thank you was meant for me also /forums/images/graemlins/blush.gif /forums/images/graemlins/grin.gif

Becky (screen name change TillyB to Batche33)
Dick's daughter

 

[Agentiron]

Well of course I ment you too Becky! /forums/images/graemlins/grin.gif I could not detect your feminenity from your previous posts, but will try to be more careful next time. /forums/images/graemlins/smile.gif

 

[Batche33]

You telling me TillyB sounds like a guy ? /forums/images/graemlins/grin.gif

 

[Agentiron]

Of course it does not sound like a guys name silly, but when I wrote thank you gentlemen you only signed it Batchelders. That makes it a bit tough to determine. Had I looked at your profile I would have seen your full name, and boy is that a mouthful. Did you marry so that you could have that name? /forums/images/graemlins/grin.gif I think it is pretty cool actually.

 

[Batche33]

Nah, I married cuz he's a great guy. Kept Batchelder cuz I'm proud of where I came from /forums/images/graemlins/grin.gif

Changed the screen name because it doesn't warrant much credibility.

I do the posting because my dad is computer illiterate and would rather talk than learn how to use it /forums/images/graemlins/grin.gif

 

[MessickFarmEqu]

I'll chime in here since no one else has. You do you that you need to knock 30% off all the figures that are measured at the pivot pin. They are dead lift figures and not the amount of material that the tractor can actually handle.