1440v loader hyd.
- Thread starter hernando
- Start date
- Views: 9271
OP
hernando
Silver Member
- Joined
- Nov 17, 2003
- Messages
- 249
- Location
- tennessee
- Tractor
- dk 4510 kioti and a 450 case track loader
I did it again with the same results...any ideas ?? could it be set that low ?? i wont have time to check anything el /forums/images/graemlins/confused.gifse until tues.. got to get to work ...while its not raining...thanks for all the help /forums/images/graemlins/confused.gif
JerryG
Super Member
You need to do the check at (I think, old age) 2600 rpm. What rpm did you use for those numbers?
JerryG
Super Member
When you have the rpm at 2600, hold the loader valve to the lock. Then it will build pressure. If you don't do this all you are doing is testing the flow resistance in the system. Sorry that I forgot to mention that.
OP
hernando
Silver Member
- Joined
- Nov 17, 2003
- Messages
- 249
- Location
- tennessee
- Tractor
- dk 4510 kioti and a 450 case track loader
ok ...but what do you mean about the lock.....???? i promise i am not as stupid as i seem..... /forums/images/graemlins/grin.gif and i thought i knew alot about tractors.... my dad used to say : Thats what i get for thinking : thanks
JerryG
Super Member
What I mean by the lock is to push the joy stick alway to the right or left and hold it there.
JerryG
Super Member
No problem with the questions, just hope that I can help.
Yes, just hold the stick and you will see the gauge move up. Post with your results.
Yes, just hold the stick and you will see the gauge move up. Post with your results.
OP
hernando
Silver Member
- Joined
- Nov 17, 2003
- Messages
- 249
- Location
- tennessee
- Tractor
- dk 4510 kioti and a 450 case track loader
well i finally got it checked ...the gage peged at 2100psi...i was afraid to hold the valve locked to long for fear of busting a hose..do you think that is accecpable pressure ??? thanks Bruce