220-4 clutch rebuild

[jocko165]

My clutch went out on my old 220-4 this weekend. Kind of surprised but the parts seem to be readily available. What I cant find is a 13 spline clutch alignment tool. Does anyone know where I can find one or have one that I could buy, rent, or borrow? I will pay all costs associated with getting it to me and be happy to ship it back if its a loaner. Any help would be greatly appreciated. Thanks yall.

 

[lpakiz]

Unless it’s a multiple disc clutch, you don’t even need splines. So then its not a real difficult job to make one on a lathe. You just need the diameter of the pilot bearing and the minor diameter of the disc.
I’ve even made them for twin disc setups by carefully tacking a piece of keystock onto the finished pilot shaft. Make sure the shaft will slide on and off the disc(s).