VABlue
Platinum Member
My 2305 has an interlock issue somewhere that won't allow the engine to turnover. It's in neutral, the seat safety switch is bypassed (but I did reconnect it, also, to no affect), and the parking brake is engaged. The engine doesn't even try to start...
This happened after I tried to lift the rear end to add some pressure to the tires (wanted to spin them around so the valve stems were on top). The jack was on the frame that surrounds the PTO, not on the transmission housing. I couldn't get the machine up level to get jack stands under it, it would tilt to one side and I couldn't get it level. After giving up on that, I was going to back it up until the stems were on top, but now it won't start. It did turnover, but conked out because the brake wasn't engaged. I engaged it, but now it doesn't even try...
Any ideas, suggestions, or answers?
This happened after I tried to lift the rear end to add some pressure to the tires (wanted to spin them around so the valve stems were on top). The jack was on the frame that surrounds the PTO, not on the transmission housing. I couldn't get the machine up level to get jack stands under it, it would tilt to one side and I couldn't get it level. After giving up on that, I was going to back it up until the stems were on top, but now it won't start. It did turnover, but conked out because the brake wasn't engaged. I engaged it, but now it doesn't even try...
Any ideas, suggestions, or answers?