2440 hydraulic test ports

[loganhorse]

Under the steering wheel. To check for internal leakage in steering valve one needs to disconnect hose(key 34) then put cap on supply line that goes from frt pump to clutch housing.

Tx Jim where is the clutch housing line. Ive finally got around to trying to figure this out. Im having a hard time finding it.

 

[Tx Jim]

Power steering supply line(key 14) is on RH side of tractor in front of brake valve pedals.

 

[loganhorse]

Power steering supply line(key 14) is on RH side of tractor in front of brake valve pedals.

Thank you sir. I'll find these when it cools down this even and grab some plugs for both lines

 

[loganhorse]

Hopefully this will fix my 3pt dropping while running the PTO

 

[loganhorse]

Little update. Appears to only have about 2000 psi on the supply for the loader. Didn't have the fittings to cap off the steering valve so I'll do that tomorrow.

 

[Tx Jim]

With engine running,3 pt raised look in hyd filler hole for moving oil. Moving oil indicates leaking 3 pt control valve seals which can affect operation of hyd's. Female cap size for steering line should be 0.562 IN

 

[loganhorse]

With engine running,3 pt raised look in hyd filler hole for moving oil. Moving oil indicates leaking 3 pt control valve seals which can affect operation of hyd's. Female cap size for steering line should be 0.562 IN

I'll double check that today and get the line capped off and update you.