24mmX27mm Combination Wrench

[HamishMacCheap]

I recently ordered a 24mmX27mm open end combination wench for use on the 3-point nuts. It is a perfect size for my LX2610SU since it fits both the lift rod nut (24mm) and the top link nut (27mm). I found it on eBay and it is German made (Stahlwille) so I anticipate it is a quality tool. Makes life easier for me to have both sizes in hand while adjusting implements. Easy is my friend.

In any event, I want to buy the same thing for my L3302 but the same nuts are larger in size than the equivalent LX2610SU nuts and I don't have a way to measure them. Can anyone tell me the size of a L3302 lift rod nut and the size of the top link nut?

Thanks in advance for any assistance given.

 

[Chewwy]

What is difficulty with measuring the nuts on the LX2610SU?
No ruler or tape measure?

 

[HamishMacCheap]

I don't have either a metric tape measure or a metric ruler.

Even if I did, the bolt would make an accurate measurement more difficult.

 

[Chewwy]

I don’t have access to you model of machine. However, it’s not hard to convert inches to mm. Multiply the length value in inches by 25.4.

 

[NoTrespassing]

Amazon sells a 6" plastic digital caliper for $5.60.

I can't help you with the exact size, sorry. It's nice to have a caliper and thread gage handy.