since i had the lift valve replaced under warranty for the jerkiness i have noticed the attachments will only lift about 18"-24" off the ground.before the attachments would lift 3'-4' is their an adjustment on the lift height? as sometimes i cannot lift boxblade high enough to get over small dirt piles. very frustrating.
2800 lift height
- Thread starter vulcan101
- Start date
- Views: 561
Have you changed the position on your top link? Use the lower hole to create a higher lift on the implement. I don't know if the valve replacement would cause this. I have ignored all the hype and left mine alone. I never noticed anything wrong with. I can always raise it and then lower it to any microadjustment I want.
wushaw
Elite Member
If it was adjusted properly after the valve replacement then there shouldn't be any difference between the old valve and the new one. Here is a thread explaining the adjustment. 3pt adjustment
kubota_man
Member
Your lift needs adjustment. I had to take my 2800 back and they readjusted for height. Makes ya wonder why they didn't get it right the first time.
