2910 Cruise Control not working

Phazer · Feb 2, 2001

The cruise control on my 2910 stopped working again. It springs right back up when you push it forward. I'm assuming something has vibrated loose again, This happend a few months ago, and the dealer fixed it by tightening a plate underneath. I looked for an hour and could not find what he tightered. He's 2 hours away, so I hate to go there to find out something so simple. Do any of you have a 2910 service manual that would show what bolt I need to tighten?
Thanks
Jim Fulford

ronjhall · Feb 2, 2001

Jim: There are 2 pages on Cruise Control. Hope you can read my scans. The manual paper is thin and some of the back side scaned thru. Here is page 1.

ronjhall · Feb 2, 2001

Jim: this is page 2.

Anonymous Poster · Feb 2, 2001

Just a thought, hold the lever while taking your foot off the hydro pedal. You may not be allowing the latch to engage.

Anonymous Poster · Feb 2, 2001

Just a thought, hold the lever while taking your foot off the hydro pedal. You may not be allowing the latch to engage fully. Keep in mind it's not electronic it's mechanical.

markcg2000 · Feb 2, 2001

Ron, I think you slipped up... the "2" file is exactly the same as the "1" file /w3tcompact/icons/crazy.gif

<font color=green>mark</font color=green>