I recently made this 3pt. combo hitch for my tractor. Having to always move trailers and such, I saw one of these and had to make my own. It will accept any ball on lower unit and on top will accept a 2 5/16" ball for those goosenecks trailers. Got material from my brothers old truck bumper and modified. Material is 1/2" x4" x 4" angle iron.
3 pt. combo hitch
- Thread starter jnich17
- Start date
- Views: 1879
bironacad
Platinum Member
Looks good :thumbsup:I like that you could use found material. I made something similar except the vertical tube I left uncapped so that I could slide in different receivers. The vertical tube was 2.5 x 2.5 which gives the 2x 2 inside. I welded up a piece that would work for my fiver trailer that slides in I also made another that goes on a skid steer plate with the same ides of sliding in different receivers plus a boom pole. I should get some pictures to show but it is not painted and probably will remain that way for several years, lol.
ruffneck
New member
That is an excellent job, thanks for posting
