3025 wont start. Seat switch?

[Doofy]

My 3135 has a cab but I could see the seat safety switch wiring but could not see where it was routed from. Came out from the middle of the back of the seat and went down and around the right side of the seat and disappears.

You obviously need to find that wiring harness. I will search my manual for a wiring diagram.

 

[gersus]

Ok, thats cool. Mine has the grommet but isnt in the hole in the center. Theres a flat bar running across the middle of the hole. I’ll check the right side again and hopefully a 3025 owner will chime in too.

 

[Doofy]

Tried looking at the electrical section on the computer but by the time I blow it up large enough to read...it is all blurry. That seat safety switch wiring has to make it to under the dash and to the ignition switch, I would think. That wire had to drop down and out of sight somewhere there. On mine the two wires are in a soft black vinyl loom about 1/4" in diameter.

 

[gersus]

Ok thanks for your help!

 

[Doofy]

gersus, Having any luck with your starting issue? Have you found that seat switch wire yet?

 

[gersus]

Went back to the property today and it started right up. So idk what was up. I shut it off a couple times and it started back up just fine.

 

[Doofy]

Went back to the property today and it started right up. So idk what was up. I shut it off a couple times and it started back up just fine.

Good deal! Must have been something hanging up or not quite right in the start circuit or safety circuits. I had a shuttle shift once that would sometimes hang up and it wouldn't actually be in neutral to start. Hope you find the culprit!