3054 ignition problem

[sigma6]

Will not start. Does not seem to be getting 12vdc from ignition switch to solenoid. Does anyone know if this line is fused? All the fuses I found are good. A schematic would be great if someone has one. Thanks.

 

[wallace]

Are you getting any power?
Do the lights work?
Did you make sure your shuttle lever is in the neutral position.
Just some basic questions.

 

[sigma6]

lights work. Shuttle lever correct. everything seems to be coming on, except starter. I measured the the voltage on the small wire on solenoid and I have 0 vdc. I applied 12vdc to that wire and it fires right up.

 

[Patches]

I would guess it's your safety switch; clutch. Make a small jumper(I use 12ga. house wire) and bypass the switch where it plugs into the harness, under the left floor board. I don't believe there is a shuttle safety switch. If this doesn't solve your problem, I'd look at the ignition switch

 

[kentrodngun]

Sounds like you're close to solving the problem, so I digress.

Your choice of ID intrigues me (as a retired Six Sigma Master Black Belt). Are you a disciple? If your answer is a long one, please send it via PM.

Best regards, John A.