3510 Lift Capacity & Hydraulic Pressure

[DavesTractor]

My 3510 is a shuttle shift.

So you have a ML112 loader. The hydro used a ML108. rback33 will have to advise, but that tractor may have a prince valve with a pressure relief in the valve.

 

[Keith_B]

So you have a ML112 loader. The hydro used a ML108. rback33 will have to advise, but that tractor may have a prince valve with a pressure relief in the valve.

According to the ML112 manual that came with my loader the relief valve is part of the loader control valve.

 

[DavesTractor]

According to the ML112 manual that came with my loader the relief valve is part of the loader control valve.

The Nimco valve was used for quite a while and it had the pressure relief in the valve, but they are no longer used. I just went out to the lot and looked at a new 3510 shuttle with ML112 and Prince valve. This valve does not have a relief, so Mr. rbackk33 is likely correct on this one. So the poster will have to ask the dealer to check the tractor system pressure relief.

 

[rback33]

The ML112 with the Prince valve does not have a relief. I believe that the only loader 112 or smaller to have a relief was the 108H on the 2810 and 3510 HST. I would have to check the cheat sheet in my desk to be sure.