3ph adapter on loader arms
- Thread starter eteagle
- Start date
- Views: 845
Gary_in_Indiana
Elite Member
- Joined
- Apr 22, 2002
- Messages
- 3,373
- Location
- Fort Wayne, IN
- Tractor
- John Deere 4200 MFWD HST w/ JD 420 FEL w/ 61" loader bucket & toothbar & JD 37 BH w/ 12" bucket
If you can weld, virtually anything is possible. /forums/images/graemlins/smile.gif This sounds like a fairly simple project, actually. Why to you want the Speeco up front? Looking to use a back blade for snow plowing or use a set of pallet forks up front? Just curious... /forums/images/graemlins/smile.gif
Hoeman00
Platinum Member
- Joined
- Jun 29, 2002
- Messages
- 872
- Location
- N Central Ohio
- Tractor
- NH TC35D/SUPER H&M/F-20/JD B&D/FORDSON/JD250 SSL
Can u weld or are u looking for parts?
ATI which advertises on here has the adapter to go on your loader to the skid steer loader(SSL) mount.
U could use SSL buckets or weld the plate to your bucket.
Then get the SSL to 3 PT adapter and u are set.
I built a SSL to 3 PT on a plate so I could take the Speeco QT off and use it on the tractor.
4 pcs of 2x3x1/4x18" or so long angle for the pivots and 2 pcs 3x4x1/4x 36" long angle for the top and bottom cross pcs will build the frame.
I used 1x3x5" strap w/7/8 hole for the bottom pins and 2pcs of 3/8" thick straps for the top link.
ATI which advertises on here has the adapter to go on your loader to the skid steer loader(SSL) mount.
U could use SSL buckets or weld the plate to your bucket.
Then get the SSL to 3 PT adapter and u are set.
I built a SSL to 3 PT on a plate so I could take the Speeco QT off and use it on the tractor.
4 pcs of 2x3x1/4x18" or so long angle for the pivots and 2 pcs 3x4x1/4x 36" long angle for the top and bottom cross pcs will build the frame.
I used 1x3x5" strap w/7/8 hole for the bottom pins and 2pcs of 3/8" thick straps for the top link.