gt14
Silver Member
I am fabricating a Cat 0 hitch that will fit a yanmar GT14 or YM146 I am looking for a couple of measurements. If anyone has these I would appreciate it. Here is a photo of the measurements I need.
3-Point Hitch 3Pt Hitch Measurements for Cat 0 Hitch
- Thread starter gt14
- Start date
- Views: 3019
mark777
Veteran Member
- Joined
- May 16, 2004
- Messages
- 1,300
- Location
- S.E Texas
- Tractor
- Ym1300d-1401D-1601D , 1610D & Massey Ferguson 1020
gt14,
Measuring the 1300 and 1401 with Cat 0 hitch I get:
A: 26 1/2" overall length on short arms
B: 10 5/16" from end to hole center
C: 13 1/16" AND 10 1/8" (I have two holes)
D: No hole on any of my cat 0 hydraulic actuator plate*
E: 2 7/8" overall length
*: 2 1/16 center to center
Hope this helps.
Mark
Measuring the 1300 and 1401 with Cat 0 hitch I get:
A: 26 1/2" overall length on short arms
B: 10 5/16" from end to hole center
C: 13 1/16" AND 10 1/8" (I have two holes)
D: No hole on any of my cat 0 hydraulic actuator plate*
E: 2 7/8" overall length
*: 2 1/16 center to center
Hope this helps.
Mark
OP
gt14
Silver Member
Is the postion of the leveling arm that attaches to the lift bars approx. in the middle of the bar?
OP
gt14
Silver Member
Do you have a schematic or pic of your 3 pt hitch?
