3rd valve hydraulic control

[Bradbilt]

I just purchased a Ford 260C Industrial tractor and it has a 744 Loader on it
It has a outlet in the back(and yes I CAN use it, but don't want to)

I would like to some how plumb a 3rd valve to the bucket for my newly purchased grapple bucket and future power angle snow plow.

Now here is where I am in over my head....
I would like to control that 3ed valve with a "switch". Whether a push button, roller or toggle. And also mount it on the loader joystick so it is more user friendly than the 3rd valve under the seat
I guess what I am looking for is switch kinda like a pilot control on a skid steer.

Any ideas or suggestions?

 

[J_J]

Do you want a selector valve that will use the curl circuit to control the grapple by using a switch.

SAE 8 15 GPM DOUBLE SELECTOR VALVE 12 VDC P15544-1

or

True 3rd function valve.

12 VDC 10 GPM OC DA SOLENOID VALVE

You need one of these to mount the solenoid on.

1 STATION DO3 SUBPLATE OPEN CENTER

You would connect this valve assembly after the loader valve using the PB port and the OUT port of the solenoid valve will go on back to the remote or 3pt.

 

[Bradbilt]

Any suggestions for a switch?

 

[J_J]

I would use a water proof switch in a factory handle or make your own.

A boat place would have the switches.

 

[Bradbilt]

I found this made by Scorpion
X series
Scorpion Technologies LTD. - X-Series

My current joystick has a "disconnect" switch already to disengage the transmission, so you can throttle up to move the loader faster but not move the machine.
I figured the trigger would be perfect for that and the push buttons could control the 3rd valve

Good idea?

 

[Bradbilt]

Ok. Back at this. Does anyone have a "schematic" as to where to tie into the loader hydraulics? Ford 260C w/ 744 loader.

Also, I am pretty sure I want to go with one of these controllers(S or C with the trigger and a roller switch and 2 momentary switches)
Sure Grip Controls, control grips and industrial joysticks for mobile equipment

 

[J_J]

Do you have a PB line or a hyd block?

If so, add your solenoid valve in series with the PB flow.

 

[Bradbilt]

I don't know. How can I find that out?

 

[J_J]

If you don't have a manual, then you have to start with the pump and follow the hoses and draw out what you have.

Anyway, if you have external hoses from the pump, you can add valves in series with the hyd flow.

 

[Bradbilt]

Ok, thanks. I wasn't sure if I could add another block in the loader controls and control it with electric solenoids