I have a KingKutter rotary cutter. The manual states not to use it at faster than 540 rpm. I do not have a tach. on my machine. I have a Mitsubishi D2300 the PTO has 4 speeds. What gear should I be cutting in?
Rotary Cutter 540 rpm on rotary cutter
- Thread starter fyrcapt
- Start date
- Views: 1248
RoyJackson
Rest in Peace
- Joined
- Nov 17, 2001
- Messages
- 23,144
- Location
- Bethel, Vermont
- Tractor
- John Deere 4052R Cab,, Deere 855D UTV, Z920A Zero Turn Mower and assorted implements
I would hope you had an owner's manual..but I reckon you don't.
I cannot help you, but there is a Mitsubishi forum that you should post this question in..
Good luck!
I cannot help you, but there is a Mitsubishi forum that you should post this question in..
Good luck!
greg_g
Super Member
- Joined
- Dec 18, 2003
- Messages
- 6,126
- Location
- Western Kentucky
- Tractor
- JD3720 Cab, 300X loader with 4-in-1 bucket
</font><font color="blue" class="small">( What gear should I be cutting in? )</font>
FWIW, your manual should also state that mowing at LESS than 540 rpms is not recommended either. The gear selected for propelling the tractor has nothing to do with producing PTO speed. That's strictly a function of the PTO speed select lever (if you have one) and the throttle. With the PTO spinning the mower ~540, you should then select the transmission gear ratio that produces the best cut behind the mower.
You put the speed select lever in 540, and adjust the engine rpms accordingly. I know that's difficult without a tach, so you'll have to use your ears. PTO rpms are generally about 80-90% of full throttle. Advance the throttle to full, then back off enough to hear a reduction in the rpms. That should get you reasonably close to 540 PTO output speed.
//greg//
FWIW, your manual should also state that mowing at LESS than 540 rpms is not recommended either. The gear selected for propelling the tractor has nothing to do with producing PTO speed. That's strictly a function of the PTO speed select lever (if you have one) and the throttle. With the PTO spinning the mower ~540, you should then select the transmission gear ratio that produces the best cut behind the mower.
You put the speed select lever in 540, and adjust the engine rpms accordingly. I know that's difficult without a tach, so you'll have to use your ears. PTO rpms are generally about 80-90% of full throttle. Advance the throttle to full, then back off enough to hear a reduction in the rpms. That should get you reasonably close to 540 PTO output speed.
//greg//
HayDR
Veteran Member, Approved Advertiser
Likely you all do not realize many gray market tractors have 360,420.540,720,& 1000 selector speed combinations. Usually the second from the slowest speed is correct. The 720 rpm will heat up the gearbox so it's a problem. If the cutter is in good condition or new and it is not cutting the grass off clean then likely you are using a speed less than 540. Most tractors need to be run at 80% throttle for the power range needed for the PTO.