820 Load Control o-ring and washer
- Thread starter cannedman
- Start date
- Views: 4472
jenkinsph
Super Star Member
I haven't but just brought the tractor in from the ranch and this is on my list to fix. Ordered the parts today as a matter of fact.
Tx Jim
New Member
I take a pair of needle nose pliers and squeeze o-ring together,insert in groove and use a round smooth object to get o-ring to seat.
jenkinsph
Super Star Member
Might be difficult to change without removing the cross shaft, but I agree with pinching and slight folding to work it in. I would warm a cup of water in the microwave and put the nylon washers in it to warm them up before installing them.
If you have the housing drained and top removed where you can get to the cross shaft then I would remove it then install the orings and washers. You should be able to disconnect the shaft internally and slide it either direction to accomplish this.
If you have the housing drained and top removed where you can get to the cross shaft then I would remove it then install the orings and washers. You should be able to disconnect the shaft internally and slide it either direction to accomplish this.
