A question for all you wood workers

   / A question for all you wood workers #1  

PineRidge

Super Member
Joined
Oct 8, 2003
Messages
7,580
Location
Northeast, Ohio
Tractor
LS-MT242HC
I need to find a source for the whatchamacallit hangers that can be flush mounted in wood (see picture). Can anyone direct me to a source? I have checked Restoration Hardware and carried the part into several local hardware stores with no success so far.
 

Attachments

  • whatchamacallit.jpg
    whatchamacallit.jpg
    120.4 KB · Views: 296
   / A question for all you wood workers
  • Thread Starter
#5  
   / A question for all you wood workers #8  
PineRidge said:
I need to find a source for the whatchamacallit hangers that can be flush mounted in wood (see picture). Can anyone direct me to a source? I have checked Restoration Hardware and carried the part into several local hardware stores with no success so far.

I have used Keyhole Fittings - Rockler Woodworking Tools with success in the past.
 
   / A question for all you wood workers #9  
If this is for a restoration project some sheet brass, a drill press and a jeweler's saw would turn out a copy in a few minutes. Drill some starter holes for the "keyhole", saw it out then use a fly cutter to cut the exterior. You would need the beam type of fly cutter so you can set the bit to cut toward the inside since that is the face you want clean.

Vernon
 

Tractor & Equipment Auctions

2020 VANGUARD CIMC 53FT REEFER TRAILER (A54607)
2020 VANGUARD CIMC...
2002 TOYOTA 7FDKU40 FORKLIFT (A54607)
2002 TOYOTA...
Venetian Bronze Aluminum Mailbox Post (A54865)
Venetian Bronze...
2017 Nissan Titan (A55788)
2017 Nissan Titan...
2012 Ford Transit Connect Cargo Van (A55788)
2012 Ford Transit...
2005 NORAM 65E MOTORGRADER (A52705)
2005 NORAM 65E...
 
Top