Adjusting lift arm travel ??

[drjay9051]

Enjoying my new DK40 HST.

Today i hooked up the flail mower to cut the fields. On my prior CK25 I could cut grass pretty close. I have a problem with the DK40. The flail is adjusted to cut at its lowest position but it is riding a few inches off the ground. i have MLS to fast setting and the float is full in. in spite of this I cannot get lift arms to lower any more.

Is there some type of simple adjustment I can make? it may be a warranty issue but my dealer 60 miles away and i do not have a trailer.

The lift arms do raise and lower but they do not seem to lower as much as i would like.

I wouldn't imagine going from the CK25 to the DK 40 should matter or am I wrong. Is it possible my mower is not compatible with my DK40?

The mower is a Caroni TL1500 FSC and I got a nice close cut with the CK25.

Any help is appreciated.

 

[k0ua]

Either adjust your toplink and/or change which hole the top link is in on the tractor.

 

[LD1]

IS any part of the mower at all touching the ground?

 

[Leejohn]

Lift links might have holes to lower, if not the lower links have holes and you change holes in or out to move the lower links up or down.

 

[drjay9051]

Appreciate the suggestions. Got it sorted out. I had treated myself to a TNT with my new DK and problem was my install of cylinders.

Good to go.

Thanks