anyone with this problem please advise

kac6261 · Jan 9, 2011

Just wondering if anyone has a John Deere tlb 110 and experienced the engine on but the machine won't move. Everything else works the bucket and loader. Starts right away and in A,B, or C range, which I thought that was odd when the brake was already disengaged. Will not go forward or back.

jd110 · Jan 9, 2011

I would check for any loose wires under the machine. Especially around the hydro pedals. Do you have a code flashing on instrument panel?

CurlyDave · Jan 9, 2011

kac6261 said:
Just wondering if anyone has a John Deere tlb 110 and experienced the engine on but the machine won't move. Everything else works the bucket and loader. Starts right away and in A,B, or C range, which I thought that was odd when the brake was already disengaged. Will not go forward or back.

The only time I have had something even remotely similar is when I had the ABC selector between gears.

Checklist on page 97 of your manual.

RaytheOne · Jan 9, 2011

I have a 110, but have not experienced that issue. I took a look at the Technical Manual, and one of the first steps in troubleshooting was to test the seat switch.

Give that a look and let us know. Good luck.

kjung17 · Jan 9, 2011

After checking your seat switch, look for a flashing light when you press the hydro pedal. The 110 TLB has the e-hydro transmission. Check the flashing light code against the operators guide troubleshooting section. You probably have a potentiometer out of calibration.

RoyJackson · Jan 10, 2011

She's resolved this problem (another thread). Turns out she wasn't heavy enough to engage the seat safety switch. Her husband tried it and it worked fine.
Here's a link to that thread.