Arc weld
Veteran Member
CFH not CFM.
At what pressure to replace mig gas bottle
- Thread starter kencunningham
- Start date
- Views: 25052
MinnesotaDaveChalmers
Platinum Member
I usually run out of shielding gas the same way I run out of wire - by surprise 
But that's why I have a backup CO2 bottle and stick/tig welders - because I know I get working and forget to check stuff :ashamed:
Usually when I run out, I instantly remember that the last time I said "gotta buy some wire next time I'm in town."
But that's why I have a backup CO2 bottle and stick/tig welders - because I know I get working and forget to check stuff :ashamed:
Usually when I run out, I instantly remember that the last time I said "gotta buy some wire next time I'm in town."
Texasmark
Elite Member
- Joined
- Apr 24, 2012
- Messages
- 3,703
- Location
- N. Texas
- Tractor
- Ford: '88 3910 Series II, '80 3600, '65 3000; '07 6530C Branson with FEL, 2020 LS MT225S. Case-IH 395 and 895 with cab. All Diesels
I just watch the CFMs. I notice the tank gauge, and when it gets low I just watch the flow gauge and when it starts falling from where I set it I replace. I run the #4 size cylinder from TSC and just weld for myself.
On gas, it's amazing how long they last once you get the leaks out of the hookup.
Mark
On gas, it's amazing how long they last once you get the leaks out of the hookup.
Mark