JOHNTHOMAS
Super Member
- Joined
- Apr 14, 2008
- Messages
- 7,717
- Location
- Somerset, Ky
- Tractor
- F2690 4WD RTV X1140 MX5400 HST ZD1211
Found a round pin on the ground about 6" long and had a small leg off one end that made it look like a L. It looked shiney and new. Looked around my B3200 and found that it's the pin that holds the QA (not SSQA) bucket on at the bottom. The remaining pin had a ring clip holding it on. I put the found pin back in it's slot and pulled the retaining ring clip off of the other pin to remind me to get another retaining clip. Brother needed some holes dug while I have post hole digger on the tractor. Yesterday morning I dug him some holes and then remembered I had the retaining clip off the tractor. That's right, I had lost the pin that had fell out before. Looked everywhere that I thought I had been but no pin. Course I knew where I could get another pin and stopped by Barlows Equipment on my way home and for only $17 and tax got another pin plus retaining ring. Check your pins and retaining clips unless you want to spend an extra $20. Steve is conferring with Brady to decide if I can do deal number 9 with them. Hope they decide before I leave town Thursday for a few days. Looking to leave them a BX2350 MMM with 30 hours and take home a BX2660 MMM FEL.