Oil & Fuel B7100 fuel in oil pan

   / B7100 fuel in oil pan #1  

hcarter62

Member
Joined
Mar 29, 2002
Messages
43
Location
Saco, ME
Tractor
N.H. TC21D, JD 325 Case 1140
I just picked up a 1982 b7100 4WD with 1900 hrs on it at an auction. Upon pulling the dipstick I noticed thier was deisal fuel smell to the dipstick and it was over full. Any ideas? also, I find out it occasionly would run backwards. Stuck injector?
Thanks
 
   / B7100 fuel in oil pan #2  
Check the diaphram in the fuel pump, they were famous for getting a hole in them and allowing fuel in the oil, and many times, oil in the fuel.
 
   / B7100 fuel in oil pan
  • Thread Starter
#3  
Thanks, as soon as I pick it up it will be the first thing I check
 
   / B7100 fuel in oil pan #4  
Well, I dunno, I have been workin' on these tractors for over 15 years, and I have "never" seen a hole in a fuel pump diaphragm. Maybe it only happens in some areas. That's about all I work on are old B's and L's. Problem is more than likely your nozzles (injector tips) Runnin' old fuel, causing the tips to stay open or improperly spray into the combustion chamber. Makes the fuel "drip" rather than disperse. Then the feul runs down through the rings into the crankcase. You can get brand new nozzles for this thing for about 60 bucks apiece I believe. They can also be leak tested and rebuilt, but for the time needed to do that, is is almost cheaper to just replace them, know they are at factory spec, and off yago. Also, get some fuel conditioner, maybe flush the fuel tank, new fuel filter as well.
 
   / B7100 fuel in oil pan #5  
I'll put my vote in for the diaphram.
 
   / B7100 fuel in oil pan
  • Thread Starter
#7  
Thanks for all the input folks I am going to pick up the tractor tommorrow, and I think I will check the diaphram first then the injectors
 
   / B7100 fuel in oil pan
  • Thread Starter
#9  
Well folks it was not as easy as a bad diphram on the fuel pump. I guess my next move is check injectors or the seal on the injector pump
 
   / B7100 fuel in oil pan #10  
It shouldn't be the seal on the injection pump. Start with the nozzles.
 

Tractor & Equipment Auctions

2016 R&R Products 331 LP Reel Mower (A51691)
2016 R&R Products...
New/Unused Agrotk Horizontal Band Sawmill (A51573)
New/Unused Agrotk...
2007 Chevrolet C4500 4x4 Dump Truck, VIN # 1GBE4C3247F411826 (A51572)
2007 Chevrolet...
Quick Attach Skid Steer Plate (A51573)
Quick Attach Skid...
2020 Chevrolet Silverado 3500 HD 4X4 Service Truck (A52377)
2020 Chevrolet...
2010 John Deere LA105 36in Riding Mower (A51694)
2010 John Deere...
 
Top