kdk1025
New member
Has anyone swapped a Honda GX390 for a Chinese copy? Will they bolt up?
BCS Engine Swap
- Thread starter kdk1025
- Start date
- Views: 6880
CowboyRon
Platinum Member
Yes, the bolt pattern should be the same.
Which copy are you looking at, and what is wrong with your 390?
CowboyRon
Platinum Member
PM sent
goeduck
Super Member
Also curious what happened to the Honda GX. I did not know they could ever die unless they were run without oil or some such fate.
Hiptfarms
Gold Member
- Joined
- May 23, 2013
- Messages
- 307
- Location
- Fairfield County, SC
- Tractor
- Kubota M6800 with BH FEL, Kubota L4400 HST with FEL, Polaris Ranger, BCS 720
I made the swap with an 8hp Harbor Freight engine this past summer on a BCS 720. It bolt up went fine. My problem was getting the cone clutch off the old engine shaft. And the new engine works very well. Good luck with your swap.
- Joined
- Feb 21, 2003
- Messages
- 26,972
- Location
- SE Michigan in the middle of nowhere
- Tractor
- Kubota M9000 HDCC3 M9000 HDC
They can die, believe me. Had one on my rear tine tiller and it tossed a rod after about 10 hours. I got no satisfaction from American Honda nor the servicing dealer locally. It now has a Predator motor on it. Been 3 years, no issues. I landfilled it (after I drained what oil was left in it), poured it out through the hole in the block.
Never again
- Joined
- Feb 21, 2003
- Messages
- 26,972
- Location
- SE Michigan in the middle of nowhere
- Tractor
- Kubota M9000 HDCC3 M9000 HDC
I'd love to have a BCS-Mosa with a Hatch diesel on it. Thats the cat's meow.
