I would have thought the slats would lay inside the angles as well. It would help locate them so the slats wouldn't fall off. We'll the ends of the rails have the cast iron keys that position the angles turned down, not up. Therefore the slats sit on top of the angles. I'll decide later if I want to mechanically fasten the slats to the rail.
Bed stretch project
- Thread starter Cord
- Start date
- Views: 2920
I would have thought the slats would lay inside the angles as well. It would help locate them so the slats wouldn't fall off. We'll the ends of the rails have the cast iron keys that position the angles turned down, not up. Therefore the slats sit on top of the angles. I'll decide later if I want to mechanically fasten the slats to the rail.
Actually, it's more about justifying the gear that I currently have. I did score a MK spool gun yesterday, but it's for an aluminum project that I have. Picked up a nice flat bed two place trailer that suffered for some serious dielectric corrosion. It'll be a project for sure, but we'll get it.
Big Barn
Super Member
- Joined
- Aug 20, 2013
- Messages
- 6,874
- Location
- Victoria, B C
- Tractor
- More than 40 over the years. Ten at any one time. Mostly Ford and New Holland
Very nice job of finding something you like and modifying it to make it work for you!
MinnesotaDaveChalmers
Platinum Member
Very nicely done, creative solution - I like it 
two_bit_score
Super Star Member
- Joined
- Dec 22, 2008
- Messages
- 10,983
- Tractor
- John Deere 110 TLB, Diamond C 19LPX GN trailer
We do what we gotta do. :thumbsup:
