Molerj
Platinum Member
- Joined
- Jul 18, 2001
- Messages
- 609
- Location
- Eastern Ohio
- Tractor
- JD 955, 1978 Economy Power King, JD X500
Well, I either bent the blade or the spindle on my 72" MMM. I got on top of a low stump
that the deck went over & kinda hit pretty good the other day. Today I sharpened the
blades & noticed the center is cutting lower. Didn't have alot of time to check things out
before coming to work, but the center blade cutting edge to the side blade cutting edge
is about 1/2 inch off (ouch). Tomorrow if time permits I will remove deck & see where the
problem is. I imagine the center spindle or whatever I'll have to buy is going to be pretty
pricey. Kinda hoping it's the blade, but I doubt it cause I didn't notice anything wrong when
I had it off to sharpen it.
that the deck went over & kinda hit pretty good the other day. Today I sharpened the
blades & noticed the center is cutting lower. Didn't have alot of time to check things out
before coming to work, but the center blade cutting edge to the side blade cutting edge
is about 1/2 inch off (ouch). Tomorrow if time permits I will remove deck & see where the
problem is. I imagine the center spindle or whatever I'll have to buy is going to be pretty
pricey. Kinda hoping it's the blade, but I doubt it cause I didn't notice anything wrong when
I had it off to sharpen it.