BH6000 question

[kcook]

Looking at a Cub SC2400 sub cut. How do they attach to tractor? Is this a good BH? What kind of cost would I be looking at?

Thanks

KC

 

[buckwheat]

The BH6000 attaches to the tractor via a four point subframe. The subframe is essentially a parallel frame section that runs up to the front end loader mounting points. The BH6000 is comparable to OEM models. You will end up paying $3500 - $6000 for the BH6000 plus about $700 - $1200 for the subframe. Additional buckets run $400 or so. It will take a good 8 - 10 hours to install a subframe unless you are very proficient mechanic.

Since you are in Michigan, you might want to look at Rosseel's. They sell through ebay and are a Woods top 10 dealer. They are/were auctioning one for $3500 w/o subframe.

Never seen one on an SC2400; I've been running one on a MF GC2300. It struggles at times with a 16" bucket. A 12" bucket is probably a better choice.