muddstopper
Veteran Member
Exact same vice I have in my shop, except mine is missing swivel base. The jaw was broken at the round stock when I got it. Welded it with 7018 about 25 years ago and its held ever since.
broken vice qustion
- Thread starter jack707
- Start date
- Views: 8232
I broke my 6" vise in the channel part 10 years ago, I went to the welding supply store, bought some 1/8", 11018 stick rod, I v it all out, shined it up, looked like cast iron. Then started welding, had to pause here and there because it got hot, tried to keep it under 300 degrees, lost count of the rods but probably used 2 lbs. or so, still using the vise today but I no longer put a pipe on the handle, hand tighten only.
jwmorris
Veteran Member
- Joined
- Oct 3, 2007
- Messages
- 1,093
Thanks for the laugh.
OP
jack707
Veteran Member
I'll have my new wilton vice 6" by end of the week!. I should of known better then to buy a vice at H.F. most of there stuff is MADE IN CHINA JUNK!.
Deere Dude
Elite Member
- Joined
- Feb 10, 2011
- Messages
- 4,013
- Tractor
- John Deere 3720
I bought a 5 or 6" HF vise about 15 years ago and beat on it and used it a lot and has worked out well for me.
Last summer I bought another 6" HF vise when near a store and installed it and the difference was amazing. Just the weight was half of the older one. The jaws section that clamps the material was quite a bit smaller in square inches and the throat of the face is way lighter duty. Glad I got an old one. I don't think I will pound on the new one after reading these comments.
Last summer I bought another 6" HF vise when near a store and installed it and the difference was amazing. Just the weight was half of the older one. The jaws section that clamps the material was quite a bit smaller in square inches and the throat of the face is way lighter duty. Glad I got an old one. I don't think I will pound on the new one after reading these comments.