Brush cutter hydraulic motor

[MossRoad]

I did a Google search on the Danfoss 151-2121 and found the following:

<font color="red">Charlyn (H) Series - #101-1001
or
Danfoss - #151-2121
or
Ross - #MK021310AAAB
The motors are interchangeable mount and capacity but if parts are required
you should specify the make and the model to obtain the correct parts from
any hydraulic repair depot.</font>


It was in reference to some sort of agricultural equipment. Maybe someone can cross reference these motors to see if they are indeed interchangeable.

 

[Aaron60]

Thanks for everyone's help. I was actually able to determine that it is a DH50 based on measurements, but wasn't able to figure out the code number (151-2121). I'll probably try the Charlyn or Ross due to the fact that I don't think I abused the old motor enough for it to have died. Thanks again for everyone's help.

Also, I understand why Power-Trac makes you pay a little more. Heck, John Deere makes you pay twice as much for an oil filter with a deer on it that can be bought anywhere else, but that's one of the reasons I didn't buy a John Deere. I'd think Power-Trac would be smart enough to make their money off the initial sale of their equipment and then keep you coming back for more along with spreading the word of their great machines by having good support (including a reasonable mark up of parts... more like 20%, not 100%). Guess not, but that's why we have TBN.

Thanks again!