Anonymous Poster
Epic Contributor
- Joined
- Sep 27, 2005
- Messages
- 29,678
Purchased a BX 2200 with MMM, FL,rear blade 6/29/02. Delivered 6/30/02. After delivery the first thing was to check out the unit to make sure a of the fluid levels where at the proper levels. Decided to go out and play a little. Grass was cut already and I tried to match the mower setting to the existing cut. In doing so I noticed that anti scalping wheels did not look right. On two of them the bolt wore into the wheel about 1 ". Pins were set at 4holes showing at the top from the dealer. Went to check my manual and found the wrong one, dirty, holes in it and actually for the 7500 model deck. The tractor manual had most of the pages stuck together. Needles to say I was PO. Now I have a major oil leak at the left side of the tractor looking from the rear. Nothing showing in the little dip stick. Any suggestions. If I would have a trailer to transport the unit would be sitting at the dealer and I would demand and get my money back. $12000 is a lot to pay for a piece of---------. Thanks for any input. Of course I must mention that this is Florida and things get done differently here(BARF) Thanks for any help