BX 24 Length

[teachdocs]

You can turn the BH to the side and probably be under 14 feet?

 

[golfbum]

MacTractor, try to design a 10' tall door opening so you can get the BX24 under it. I have a 9' in my basement garage and it is a couple of inches short to get under it without the ROPS folded.

Actually it would get under a full 9', but the door wont roll up the last few inches to get the full opening. There may be a way I can adjust the door to get it up the last little bit.

Marv

 

[tommu56]

You can turn the BH to the side and probably be under 14 feet?

and chain across the out riggers and lock the boom up but not straight out.

tom

 

[MacTractor]

Wait, I'm lost here. I hope you mean 8ft not 10ft. I just changed the design on my house to make the doors 8ft instead of the standard 7ft. When I look online at Kubota it shows that the BX24 is 85.4" tall with the ROPS not folded. This should mean that it should fit in an 8ft door with room to spare. (I hope)

Someone please correct me if I'm wrong!

Cheers,

MacTractor, try to design a 10' tall door opening so you can get the BX24 under it. I have a 9' in my basement garage and it is a couple of inches short to get under it without the ROPS folded.

Actually it would get under a full 9', but the door wont roll up the last few inches to get the full opening. There may be a way I can adjust the door to get it up the last little bit.

Marv

 

[golfbum]

MacTractor, you are correct, I am wrong. My basement is 10", but my door is 8'. I had to pull out the tape measure as I was thinking it was a 9 foot door.

My BX24 will not come in the 8' opening, because the door will not go up the extra few inches to get the full opening.

Sorry I confused you.

Marv