BX Skid Plate

[bird1968]

Hi Mike,

I do not have a MMM, but do believe that the MMM would work, the drive shaft (joint on/off, no problems) comes out of the 3"hole, u may have to make it oval, to take up the range. The link bar are not in the way. A plug cap for the hole, is in the works, for when the Drive shaft is not used & the drain & filter access are all accesible with the skid plate installed.

Thanks for the comments, I may start the production line, if the orders/request still keep comming.... /forums/images/graemlins/wink.gif

 

[twinsticks]

Okay I will buy one!

 

[Wood_Butcher_Dav]

Put me on that list !
Better yet just come up with some full scale plans that could be purchased.

Dave

 

[SCB]

I agree. You could sell many of those. Including one to me /forums/images/graemlins/smile.gif

 

[Lockport]

</font><font color="blue" class="small">( ... full scale plans that could be purchased. )</font>

That would work for me. I'll take em to my local Canadian machine shop. /forums/images/graemlins/grin.gif

 

[bird1968]

Here an updated version, with a slide door protection

Also more travel was added for a MMM.

I may get a MMM from the dealership to fine tune the skidplate design & test run. I may take u guys up for the $45.00 design, if I make this extra effort.

The next one I make will be for Yankee, new & improve.
Let me known you else would like to be on the list for the final spec. for $45.00 This would be a Step by Step info on installation & spec, email to you.

 

[arleyp]

i'll buy one also-or at least the plans.

 

[bird1968]

Another pic

 

[bird1968]

pic2

 

[bird1968]

Pic with Shaft