Anonymous Poster
Epic Contributor
- Joined
- Sep 27, 2005
- Messages
- 29,678
bx2200 top \'n tilt
Hi folks,
I posted over in the attachment forum regarding a Woods gb as against gbc box blade. RaT came back and mentioned top'n tilt. IF I could convince the wife I needed (wanted) it, I'm thinking about doing it. I know I need the rear remote setup for a bx22 that was on a previous thread, plus a 2 spool valve and cylinders. If I picked up the fel 4 way valve could I use the old 3 way valve for the top 'n tilt? Has anybody done this on a bx2200? Any idea on cylinder sizes? I'm assuming that the top link cyl. would have to have an open length equal to the top link length when fully extended. The tilt cyl. is the one I wonder about. should it extend beyond the existing link length? if so, how much?
thanks,
DaveL
Hi folks,
I posted over in the attachment forum regarding a Woods gb as against gbc box blade. RaT came back and mentioned top'n tilt. IF I could convince the wife I needed (wanted) it, I'm thinking about doing it. I know I need the rear remote setup for a bx22 that was on a previous thread, plus a 2 spool valve and cylinders. If I picked up the fel 4 way valve could I use the old 3 way valve for the top 'n tilt? Has anybody done this on a bx2200? Any idea on cylinder sizes? I'm assuming that the top link cyl. would have to have an open length equal to the top link length when fully extended. The tilt cyl. is the one I wonder about. should it extend beyond the existing link length? if so, how much?
thanks,
DaveL