Calling all CK2510 owners

[southernAL]

Recently there has been another thread posted about the KL6010 loader arms uneven. I have noticed a while back that my loaders arms(KL2510) on my CK2510 were also uneven,the right side is lower than the left. I just thought that it was "normal" or that maybe I just worked the right side harder than the left. But after reading in that thread, i'm just not so sure that is the case. Maybe i'm just paranoid or OCD but it would be nice to hear some input from CK2510 owners if they are experiencing the same issue. My right arm sits 1/4" or more lower than the left. Thanks

 

[rimshot]

Recently there has been another thread posted about the KL6010 loader arms uneven. I have noticed a while back that my loaders arms(KL2510) on my CK2510 were also uneven,the right side is lower than the left. I just thought that it was "normal" or that maybe I just worked the right side harder than the left. But after reading in that thread, i'm just not so sure that is the case. Maybe i'm just paranoid or OCD but it would be nice to hear some input from CK2510 owners if they are experiencing the same issue. My right arm sits 1/4" or more lower than the left. Thanks

=====================================================

Does not seem a problem to my ck2510. I have had thiis tractor for over two years and it currentlyi has about 207 hours recorded.

rim

 

[BC Boy]

I had a FEL mount weld let go on my ck2510, I think my tractor is 2014 Kioti redesigned the 2016 mounts. It made the FEL look uneven. my dealer did a re-weld and added additional support to the mount...Hope this helps

 

[George2615]

Have you checked the air pressure in your tires? A low tire will cause the loader to be uneven.