cat.1 3pt A-frame for tool bar...Where?

[gungadins]

Hello, I am looking for a little help. I am looking for a Cat.1 3pt A-frame that I can attach a 5 foot 2 1/4" square steel tube to use as a tool bar. I know such a monster exists but cant find one anywhere. I know one can be constructed if I was a welder, but these 3pt frame do exist. Thanks much.

 

[gwdixon]

Bump. I was going to post the same question but ran across this entry.

A friend destroyed his disc's three-point frame and I'm looking for an A-frame to weld on in its place. If anyone has a source for a heavy duty A-frame, drawbar, tool bar, or whatever you want to call it please give us a clue. The place I usually buy them has gone out of business and the manufacturer is also no more.

Thanks.

 

[gwdixon]

After several hours of searching a company was found in Fresno, CA, that makes them. It is called Wasco Hardfacing.

Wasco Hardfacing Company, Inc., Tillage tool Distributors, Cultivating equipment distributors, Manufacturers

 

[boxorox]

tractortools.com or tractorpartsasap.com

 

[wolftree]

"redlandhill.com" is another source

 

[Don87]

The thread is 3 years old, and the OP has never been back.

 

[Neimeroff]

Part # AS3-1D - Norwest Category 1 - 3 Piece A-Frame Norwest A-Frames fit 2" to 2 1/2" tool bars and are made of high carbon alloy spring steel. The three piece design is narrow enough to fit any row spacings, yet wide enough between the masts to accept any cultivating tools for working the middle furrow. Category I frames are formed from 3/4" x 2 1/2" stock. Category II frames are formed from 1" x 3" stock. All A-Frames are stress relieved to assure and enhance maximum strength and service. Rupert Idaho Norwest Man. Inc , 300 bucks