Mowing Cleaning Mower Deck

   / Cleaning Mower Deck #1  

Anonymous Poster

Epic Contributor
Joined
Sep 27, 2005
Messages
29,678
Glad I bought the loader. This deck is heavy. The deck will clear the ground with a foot to spare with the loader fully extended. I've got to get a power washer. It never ends.
 

Attachments

  • 247705-CleaningMower3.jpg
    247705-CleaningMower3.jpg
    45.9 KB · Views: 438
   / Cleaning Mower Deck #2  
Jimmo,

When I lift my deck with the FEL I usually lift it from the wide end. This way you can get it higher and then when working on it everything is more on the same level. Also you can lift it so the bottom side is facing away from the tractor making it easier to work on.

Just a note for you


murph
 
   / Cleaning Mower Deck
  • Thread Starter
#3  
Thanks Murph, thats sounds a lot easier. I'll try that next time.
 
   / Cleaning Mower Deck #4  
Pallet forks are also good for working under a mower - put the forks under it, roll it gently back, and lift it to a comfortable working height.
Mark
 
   / Cleaning Mower Deck
  • Thread Starter
#5  
I tried a coating on the 54" deck of my x595 last summer. It is a graphite loaded acrylic that is quite resilient. The intent is to prevent the cuttings, which are usually a mixture of grass, dirt, and moisture, from forming a tough build-up. This crud can be really hard to remove. Long-term, it accelerates the rusting of the deck.
Anyway, the coating works well, but gets worn off by cuttings, sticks, rocks, etc from the very areas you want protected the most.
Power-washer -- haven't tried that yet.
jim
 
   / Cleaning Mower Deck #6  
I have a similar rig to yours. My solution to both transport of the MMM deck and lifting for cleaning has been to use two chains of about three foot length each with three slip hooks spaced so that the center hook can attach to the side edge of the loader bucket and the two end hooks attach to the reinforced corners of the mower deck. I can hook it up in less than a minute raise the mower to the full height of the loader (minus about 6") clean underneath with a hose with a suicide nozzle and then move the mmm to a convenient storage location using the FEL. When I need the MMM again I use the same hook up to move it from storage to a convenient installation site. This system not only allows easy cleaning it also beats trying to manhandle the mmm to and from storage.

Bill
 

Tractor & Equipment Auctions

2018 GENIE GTH-636 TELESCOPIC FORKLIFT (A51242)
2018 GENIE GTH-636...
2018 John Deere 1445 72in Front Mower (A48082)
2018 John Deere...
2012 GALLEGOS TRAILER 130BBL VAC TRAILER (A50854)
2012 GALLEGOS...
2023 MAXXD TDX Drop-N-Load Trailer with Air Ride Suspension and Tilt Deck (A51039)
2023 MAXXD TDX...
2007 Ingersoll Rand P185WJD Towable Diesel Air Compressor (A49461)
2007 Ingersoll...
2018 International WorkStar 7400 T/A Dump Truck (A50323)
2018 International...
 
Top