Cold start problem

   / Cold start problem #12  
Richard, yes, absolutely correct. In the thread that I linked to it mentioned the procedure for activating the GPs- the OP mentioned that he's going to look at that. I just added the GP replacement because it's "almost" a certainty that if this thing has been neglected that there's one or two bad GPs; everyone should be familiar with how to approach changing these.
 
   / Cold start problem
  • Thread Starter
#13  
Thanks for all suggestions. Not had time to check it out yet. I do want to get it working as I use it with my power angle snow plow. 36 out side right now and to be colder through weekend. Could snow anytime now. Thanks again. Harv
 
   / Cold start problem #14  
Richard, yes, absolutely correct. In the thread that I linked to it mentioned the procedure for activating the GPs- the OP mentioned that he's going to look at that. I just added the GP replacement because it's "almost" a certainty that if this thing has been neglected that there's one or two bad GPs; everyone should be familiar with how to approach changing these.

Good advice given by all. Hopefully the OP will figure out the problem and report back the results. :)
 

Tractor & Equipment Auctions

Galvanized Livestock Wire Gate - 4FT x 11.5FT (A55315)
Galvanized...
CATERPILLAR 80" QUICK ATTACH BUCKET (A51406)
CATERPILLAR 80"...
Gas Pump Artwork (A55758)
Gas Pump Artwork...
TEST YOUR BID BUTTON! (A58375)
TEST YOUR BID...
2002 Chevrolet C8500 Flatbed - CAT 3126 Diesel - Eaton Fuller 8 plus 2 Transmission (A56435)
2002 Chevrolet...
John Deere 1025R (A53317)
John Deere 1025R...
 
Top