kennyd
Advertiser
Get a telescopic cylinder with trunnion mount, that will give much better geometry and lifting force from start of lifting cycle, short retracted with a long stroke....
see Prince catalog pdf
I doubt that's in the budget!
Cyl. force
- Thread starter Hooked_on_HP
- Start date
- Views: 2387
I doubt that's in the budget!
OP
Hooked_on_HP
Veteran Member
Get a telescopic cylinder with trunnion mount, that will give much better geometry and lifting force from start of lifting cycle, short retracted with a long stroke....
see Prince catalog pdf
You dont have one of these lying arround you would like to donate to the cause do you. I think I have to have a double acting cyl.to work with the hyd. on the tractor.
Bill
CurlyDave
Elite Member
Calculate torque around the pivot point, not force.
If you just calculate force you may be embarrassed at the county dump with a trailer full of something you don't really want to bring home.
If you just calculate force you may be embarrassed at the county dump with a trailer full of something you don't really want to bring home.
J_J
Super Star Member
- Joined
- Sep 6, 2003
- Messages
- 18,973
- Location
- JACKSONVILLE, FL
- Tractor
- Power-Trac 1445, KUBOTA B-9200HST
Here is another dump setup being worked on by rdbrumfield
Attachments
rdbrumfield
Veteran Member
I understand your problem with the 10 degree starting angle. Can you lower the front of the ram a bit? With only a 3 inch ram it isn't going to lift much very high. If you move it forward to lighten the ram load it won't pick as high. Tradeoffs are a bummer.
Lowering the ram on the subframe will give you better angle for lift and still keep the same height pretty much full extended.
Lowering the ram on the subframe will give you better angle for lift and still keep the same height pretty much full extended.
