If your lights are coming on and then you have no sound at all then one of your safety switches are out, unplugged or not in neutral. There might also be a starter relay behind the firewall.. those tractors are touchy with being jumped off by the starter and can cause electrical issues
DK40HST Won't Start.
- Thread starter Nick61
- Start date
- Views: 31235
k0ua
Epic Contributor
Keep in mind the cruise module has a history. Some percentage of the cruise modules have a temperature related issue.
OP
Nick61
Bronze Member
I am jumping at the connector for the start relay. Where is the start relay coil? I will check that also. Thanks for the input.
Nick
Nick
k0ua
Epic Contributor
There is no seat start switch, and there is no clutch on this tractor.
k0ua
Epic Contributor
Right not actually a clutch but a brake lever on the left that does have to be pushed in to crank the tractor right?
k0ua
Epic Contributor
Negative, there is a 3 range selector on the left that has to bee in Nuetral for a start to occur. It has a bellcrank on it that rotates a potentiometer that has +5 volts on one side of the pot and ground on the low side. The wiper of the pot that is connected to the bellcrank then sends a varying voltage to the cruise module. The cruise module detects that voltage and decides what position the range selector lever is in. If it is in one of the 2 neutral positions, it will throw a ground out to the low side of the start relay thru a diode.
k0ua
Epic Contributor
To directly answer your question, the start relay coil is inside the enclosure of the start relay. The first relay on the left on the firewall as you look towards the seat while standing near the engine.
