DK55 Loader Issue?

[TURKEY131]

I have a fairly new to me Dk55 with about 760 hours on it. My issue is when I have the pallet forks on the machine and I try to curl the them it will not curl. Are they known for this issue? My l35 has no real issue like this.

 

[murphy1244]

Check your disconnects! Pop them off and reconnect then post back.

 

[TURKEY131]

Ok Ill give it a shot tomorrow, thanks

 

[RandyT]

I had the same issue with my 45s a couple of years ago. slid the forks under a pile of slabs, and went to curl back, and just went into bypass. I though that was strange until I decided to just raise the pile, and instead of the loader coming up, the back tires did.

If you have a heavy load out toward the end of the forks, that is a lot of leverage for the small surface area on the retract side of the cylinders to overcome.