EZ Hitch
- Thread starter ckbrown98
- Start date
- Views: 789
ruffdog
Super Star Member
- Joined
- Dec 31, 2011
- Messages
- 12,448
- Location
- southern wisconsin
- Tractor
- Bobcat Toolcat 5610G, Deere X744, Cub Cadet IH 982
I have looked at them in the past. It sounds like they are willing to customize the product too.
Welcome to CARTER AND SON'S TOOL AND DIE
Welcome to CARTER AND SON'S TOOL AND DIE
oldballs
Elite Member
- Joined
- Dec 29, 2009
- Messages
- 4,534
- Location
- Kansas...USA
- Tractor
- Kubota B2620 , Case 448 , Kubota B2650
Carter's EZ hitch is well made. One advantage is that it does not extend the length of the PTO hookups.
shooterdon
Super Member
- Joined
- Nov 24, 2012
- Messages
- 5,236
- Tractor
- 2019 LS XR4140 HST Cab; 2025 Moto UForce 1000; 2021 Bad Boy 54" ZT Elite
I have looked at them and will likely buy one shortly. But very little info on them so welcome this post.
That's what I was thinking
CoyPatton
Veteran Member
- Joined
- Aug 10, 2015
- Messages
- 1,598
- Location
- Poplar Bluff, MO
- Tractor
- Yanmar YM2002D with Koyker 110 FEL
Never heard of them before. Looks interesting however.
I have a brand (sorry I don’t remember the name) that is a cross between these with the pins and the mounting style similar to Pat’s.
My and Pat’s do increase the distance from the tractor about 4” which can create an issue with PTO shafts being short.
The only concern for this design that I notice is if you have a low pin level on an implement especially if an implement should sink on a stand or falls from a prop some how.
I could not tell from the picture how the spacer bar is removed. If it is not removable, it may well cause interference with a PTO shaft.
I have a brand (sorry I don’t remember the name) that is a cross between these with the pins and the mounting style similar to Pat’s.
My and Pat’s do increase the distance from the tractor about 4” which can create an issue with PTO shafts being short.
The only concern for this design that I notice is if you have a low pin level on an implement especially if an implement should sink on a stand or falls from a prop some how.
I could not tell from the picture how the spacer bar is removed. If it is not removable, it may well cause interference with a PTO shaft.
