dbelisle
Gold Member
A friend of mine has a 4200 with a FEL that does't have any down pressure.
Any ideas what it might be??
Any ideas what it might be??
`FEL stays in float
- Thread starter dbelisle
- Start date
- Views: 955
Bird
Rest in Peace
Just a guess, but sounds like the hydraulic line for that function is not hooked up properly or is plugged for some reason. That would be the line that goes to the boom cylinders on the end that collapses the cylinder. Disconnect it at the valve and reconnect it to make sure it seats good and try again. And if that doesn't work, then I don't have any good ideas. /forums/images/graemlins/wink.gif /forums/images/graemlins/grin.gif
JerryG
Super Member
They may look hooked up and not be.
JDgreen227
Super Member
And check to be sure the system is full of fluid and there is nothing interfering with the lever when pushed forward.
Bird, no bearing on the matter, but it sure is easy to see where you made a post, with that colorful outfit. /forums/images/graemlins/smile.gif
Bird, no bearing on the matter, but it sure is easy to see where you made a post, with that colorful outfit. /forums/images/graemlins/smile.gif
JerryG
Super Member
It looks like he is ready for the deer woods...... /forums/images/graemlins/grin.gif
dbelisle,
Did it used to but now doesn't? Is he sure he's not putting it in to float by pushing the lever to far forward?
Mine is not a 4200, but I was having dump and float problem (not able to do either but all other functions worked) and found the bottom mounting bolt for the SCV loose. Tightened it and all is well now.
Just some ideas.
Did it used to but now doesn't? Is he sure he's not putting it in to float by pushing the lever to far forward?
Mine is not a 4200, but I was having dump and float problem (not able to do either but all other functions worked) and found the bottom mounting bolt for the SCV loose. Tightened it and all is well now.
Just some ideas.