Ferguson TO30 Steering BOx
- Thread starter Bob Senti
- Start date
- Views: 9896
banjodunn
Veteran Member
G'day Bob there is no reason that you can't fill your box with grease it just stops the oil from leaking out:thumbsup:. If you were to fill with grease i would prob thin it down a little with some gear oil so it can run into the bearing surfaces a bit easier.
Jon
Jon
Jerry/MT
Elite Member
- Joined
- Feb 2, 2008
- Messages
- 3,141
- Location
- North Idaho-The Palouse
- Tractor
- New Holland TD95D, Ford 4610 & Kubota M4500
The spec calls fro GL-1 oil( same as the transhydraulic oil use in the tranny/rearaxle/hydraulics on the tractor. The fill is 2 quarts and the level, per the TO-30 Owners Manual is "...at the center of the steering arms." I think tht means at the center line of the transverse part of the steering shafts that come out of the sector gears.
Some people fill it with corn head grease when the seals are shot and it won't hold fluid. That's a temporary fix until you can fix it correctly. It's really not designed for a grease pack.
Soundguy
Old Timer
- Joined
- Mar 11, 2002
- Messages
- 52,424
- Location
- Central florida
- Tractor
- RK 55HC,ym1700, NH7610S, Ford 8N, 2N, NAA, 660, 850 x2, 541, 950, 941D, 951, 2000, 3000, 4000, 4600, 5000, 740, IH 'C' 'H', CUB, John Deere 'B', allis 'G', case VAC
may not be designed for it.. but even ford recognised that some lube on a bearing was better than no lube.,
I have a ford service bulletin dated oct 62 advising ford dealer service departments to retro fit steering boxes with 0ep grease to combat leaky sector seals / dry bearings.
nowadays I think I would use a 00ep grease for improved flowing.
that's what I put in all my steering boxes.. 00ep stens grease.
soundguy
