You can take a look in the 'Attachments' forum under 'Forks on a FEL, economy' and take a look how the forks came about. Source would be my shop and a longtime buddy with access to worn forktruck forks. The picture in this thread is the last one posted in May after the spring logging crisis was over. As far as lifting goes: I'm pretty much limited by hydraulics and steering. My rear tires are filled and the 3pt carries a 380 pound counter weight (which must be in a thread somewhere). The machine can lift and maneuver at rated capacity however the load center is approx 18" further out from the FEL pins so I figure around 600#. I'm still waiting for the ground to freeze up so I can move the rest of the wood near the house. There was so much rain before the snow, the ground is just mush. SteveV
<A target="_blank" HREF=http://www.tractorbynet.com/cgi-bin/compact/showthreaded.pl?Cat=&Board=implement&Number=120193&page=&view=&sb=&o=&vc=1#Post120193> Forks on a FEL, economy</A>