Ford 770B loader replacement control valve

[wkualum]

Bump.

 

[wkualum]

No I know I did not get them from new holland though. Either I had a buddy of mine make some for me at his work (runs a machine shop) or more than likely they were a readily available bushing thru one of my parts suppliers at work. But way to much water has went under the bridge since then for me to remember.

Would you care to remove the top cover and take some pictures when you get some time? I need to address mine this spring.

 

[mike48130]

Messicks has all the diagrams. There are a couple bushings shown, not too expensive, but your links are probably where the slop is. Those are a lot more, but I would look to find a similar replacement. You probably need to tear it apart to measure everything.

New Holland (77B-SERIES) - FORD LOADER (1/83-12/88) Parts Diagrams

 

[mike48130]

Messicks has all the diagrams. There are a couple bushings shown, not too expensive, but your links are probably where the slop is. Those are a lot more, but I would look to find a similar replacement. You probably need to tear it apart to measure everything.

New Holland (77B-SERIES) - FORD LOADER (1/83-12/88) Parts Diagrams