Ford 8N Ignition and Resistor

   / Ford 8N Ignition and Resistor
  • Thread Starter
#11  
That I'm not sure...I just know that when I turn off the ignition switch and remove the key it sometimes continues to run. Is that something I can check with my timing light? (i.e., will the ignition system continue to spark in the case of no ignition isolation?)

-Jack
 
   / Ford 8N Ignition and Resistor #12  
easier than that.. just pull the primary wire going to the coil. if that kills it, you are still getting power to the coil with key off. most lielly cause of that when you have a 3 wire alt is no isolation in the #1 excitation line.. or incorrect isolation. less likely it's a bad key switch.

post back

soundguy
 

Tractor & Equipment Auctions

2009 DRAGON PRODUCTS 130BBL VACUUM TRAILER (A53843)
2009 DRAGON...
2010 Ford Edge SE SUV (A51694)
2010 Ford Edge SE...
Brushfox XHD-78 (A53421)
Brushfox XHD-78...
2010 Ford Edge SE SUV (A51694)
2010 Ford Edge SE...
2005 Frieghtliner 18' Box Truck (A52377)
2005 Frieghtliner...
2021 NEW HOLLAND GS72 HD FRONT MOUNTED BRUSH CUTTER (A53473)
2021 NEW HOLLAND...
 
Top