Front hydraulic couplings for grapple not releasing pressure

[RinconVTR]

If you are using a diverter or 3rd function valve then having the power off is most likely not letting them activate to relieve pressure in the grapple circuit.

I am and this does appear to be the case. I take delivery finally tomorrow and they will demonstrate the "proper" technique to avoid either side retaining pressure. They tell me quick connects on either end of the grapple hose is not needed, which I had read is how to completely eliminate the problem. We'll soon see.

Oh...temp was a non issue. We were in the shop and the tractor didnt even run for 2 minutes.

 

[N2DFire]

I am and this does appear to be the case. I take delivery finally tomorrow and they will demonstrate the "proper" technique to avoid either side retaining pressure. They tell me quick connects on either end of the grapple hose is not needed, which I had read is how to completely eliminate the problem. We'll soon see.

Oh...temp was a non issue. We were in the shop and the tractor didnt even run for 2 minutes.

Glad you found the issue (or the most likely culprit anyway).

We've had our grapple & related 3rd function for less than a year and (because it's just so dang handy) I don't really take it off till I have to have the bucket/forks so I still find myself shutting down and getting off without working the 3rd function. I usually remember it about half way to the front and have to walk back and turn the key on and cycle the buttons.

After enough time - it will be 2nd nature to both of us. :thumbsup:

Be sure to come back & share pictures. Everyone loves "tractor ****" and the law of the internet is Pics or it didn't happen. :laughing:

Enjoy the new tractor.