wow, just found this sight... way cool.....
i have a g5200 (600 hours) with an over heating problem. its driving me crazy!!!!!!! to say the least.
i have had the rad boiled out x2, flushed the block out x 4, new rad cap, thermostat, etc etc etc. i have even brought it to three diff kubota shops at least two time each. they each ran leak down test, compression test, water pump flow test, and the list goes on and on. they can not figure out what is going on with it.... anybody got any ideas?
i can cut for maybe 10-15 minutes and then it starts creeping up into the red!!
i have a g5200 (600 hours) with an over heating problem. its driving me crazy!!!!!!! to say the least.
i have had the rad boiled out x2, flushed the block out x 4, new rad cap, thermostat, etc etc etc. i have even brought it to three diff kubota shops at least two time each. they each ran leak down test, compression test, water pump flow test, and the list goes on and on. they can not figure out what is going on with it.... anybody got any ideas?
i can cut for maybe 10-15 minutes and then it starts creeping up into the red!!