LarryS
Member
Gentlemen:
I have a problem with my GC2300 MMM not lifting on one side. I have the adjustments set all the way they can go and still the left side barely lifts.
There are two potential problem areas: one is the front mount only having one pin. It looks like the pin in the left side of the picture might have been left off during assembly, or it was never meant to be there. There's a hole there for a pin, and the holes do move slightly when the MMM is raised and lowered.
The other potential is the cutting height adjustment. As you can see from my pictures, there's a LOT of play in this and I'm betting there's a part missing on the bottom end of that rod.
Any thoughts as to what's missing? I have more pictures but they didn't turn out too good. I hope the attachments work properly!
Larry
I have a problem with my GC2300 MMM not lifting on one side. I have the adjustments set all the way they can go and still the left side barely lifts.
There are two potential problem areas: one is the front mount only having one pin. It looks like the pin in the left side of the picture might have been left off during assembly, or it was never meant to be there. There's a hole there for a pin, and the holes do move slightly when the MMM is raised and lowered.
The other potential is the cutting height adjustment. As you can see from my pictures, there's a LOT of play in this and I'm betting there's a part missing on the bottom end of that rod.
Any thoughts as to what's missing? I have more pictures but they didn't turn out too good. I hope the attachments work properly!
Larry